The Digilent Cmod S6 is a small, 48-pin DIP form factor board built around a Xilinx® Spartan®-6 LX4 FPGA. The board also includes a programming ROM, clock source, USB programming and data transfer circuit, power supplies, and basic I/O devices. There are 46 FPGA I/O signals that are routed to 100-mil-spaced through-hole pins, making the Cmod S6 well-suited for use with solderless breadboards. At just .7” by 2.6”, it can also be loaded in a standard socket and used in embedded systems.
The FPGA on the Cmod S6 can be configured in several ways - from a PC using the on-board Adept USB interface or from the on-board Quad-SPI Flash memory. Configuration files can be programmed using Xilinx's ISE® 14.2 (or higher) development tools, using Digilent's Adept system, or using older versions of the Xilinx tools if Adept is also installed. Xilinx's ISE/iMPACT™ programming tool and Digilent's Adept tool will recognize the board and/or FPGA when the board is attached to a PC using a USB A to micro-B cable.
Xilinx's iMPACT tool and Digilent's Adept can both be used to program the FPGA and on-board QSPI ROM. Please refer to the ISE and/or Adept documentation for more information on using the configuration software.
- Xilinx Spartan-6 XC6SLX4-2CPG196 FPGA
- 600 slices (each with 4 LUTs and eight flip-flops)
- 8 DSP slices
- 216Kbits of block RAM
- 2 CMTs (4 DCMs and 2 PLLs)
- 16 MB Spansion® Quad SPI Flash for storing FPGA configurations and/or user data
- 46 FPGA GPIO signals brought to DIP pins
- Two on-board clock sources
- Requires a USB A to micro-B USB cable for configuration (not included)
- 4 user LEDs and 2 user buttons
- On-board Adept USB2 port for configuration, test, and communications interfaces
- Cmod S6
- Custom Digilent cardboard box with protective foam
Welcome to the resource center for the Cmod S6!
The Digilent Cmod S6 is a small, 48-pin DIP form factor board built around a Xilinx Spartan 6 LX4 FPGA. The board also includes a programming ROM, clock source, USB programming and data transfer circuit, power supplies, and basic I/O devices. There are 46 FPGA I/O signals that are routed to 100-mil-spaced through-hole pins, making the Cmod S6 well suited for use with solderless breadboards. At just .7” by 2.6” inches, it can also be loaded in a standard socket and used in embedded systems.
Here you will find all the reference materials that Digilent has created for this board, as well as links to any external content we have tracked down. If you are interested in purchasing the Cmod S6, visit the product page on our main website: Cmod S6
Cmod S6 factory-loaded demonstration project
Cmod S6 Master UCF File for ISE designs
Digilent는 70여가지의 Pmod 제품을 제공하고 있습니다. FPGA 보드의 Pmod에 커넥터에 Pmod 제품을 연결하면 보드에서 제공하지 않는 70여가지의 다양한 기능을 사용할 수 있습니다. 아래 링크페이지를 통해 다양한 Pmod 제품들을 검토해 보시기 바랍니다.